CycleOps 300PT User Manual download pdf (Page 10)

CHAPTER 4: LUBRICATION

Chain

Over time, the chain on your indoor cycle will require additional lubrication. It is

recommended that you lube the chain every six months to maximize chain life.

To lubricate the chain on your indoor cycle, use the lubrication port that is at the

back of the chain guard Liberally spray a Teﬂ on-based lubricant onto the chain.

Be sure each link gets lube. Be careful not to over-lubricate the chain as excess lube

will drip out of the chain guard and can stain ﬂ oors/carpet.

Nuts & Bolts

It is recommended that you put a light coating of lithium grease on the threads of the

following hardware to ensure proper tightening and to prevent the parts from seizing

over time:

•Stabilizer bolt threads

•Rubber feet threads

•Pull-pin threads

•Pedal spindle threads

Pull the old resistance knob out of the

handlebar.

Insert new resistance knob, paying

attention to ﬁ shing the cable and

housing through the handlebar.

Tighten the setscrew underneath to

secure the knob in the handlebar.

Insert cable through the hole in the slider

and through brass cable stop.

See CABLE ADJUSTMENT for instructions

on properly adjusting the resistance cable.

Lube Port

1 2 ... 5 6 7 8 9 10 11 12

No comments

CycleOps 300PT User Manual Page 10